Related topics

DVD-writer dieing?
CD-ROM: <IDE-DVD ROM 6116 >Version: HD24 - HA 1 TA 1 - 7.0.0.0 Adapter driver: <IDE> HA 1 === Scsi-Device-Map === CdRomPeripheral : HP DVD Writer 630c Line 289 Write in overburning mode: NO (enabled: CD) 19:57:11 #10 Text 0 File DlgWaitCD.cpp, Line 2568 Recorder: HP DVD Writer 630c 19:57:11 #11 Text 0 File

please help me,a strange DVD writer problem
Those are all the entries that are there, no parallel ATA or IDE entry. Any idea how to proceed? -- John P "sp00n" wrote: firstly open the device manager After clean installation that IDE controller was detected as something like SCSI RAID device. The correct driver for that controller is "Standard Dual Channel

DVD writer not recognised
DVD writer set as primary slave. I've had no problems until recently, when the setup stops trying to 'Auto detect Primary Master'. But my DVD writer has not been detected. I can then access data on both hard drives as normal. Either one of your drives are becoming defunc or likely your BIOS has incorrect

CD-ROM/DVD-ROM/CD-RW Drive problems
There is no real reason for a modification, and (even worse) the people who create modifications do not help to keep my workload low in order to help me (and Heiko and James) with the cdrtools ..... This is expected to free the IDE bus if the CD/DVD writer and the data source are connected to the same IDE cable.

Linux 2.6.x wrongly recognizes USB 2.0 DVD writer
So far I've had very good luck with the network and no detected failures. It's also very convenient for me to use as it's already in place. Two computers in my den, one in my wife's office I still need a long term archival system and for that my only choice I can see "so far" is an automated DVD writer/changer.

Getting FreeBSD to see my dvd drive
Depth 24 scsi1 : SCSI host adapter emulation for IDE ATAPI devices Vendor: HP Model: DVD Writer 300n Rev: 1.25 Type: CD-ROM ANSI SCSI revision: 02 SCSI device family 10 IPv6 over IPv4 tunneling driver eth0: no IPv6 routers present eth1: no IPv6 routers present [drm] Initialized r128 2.5.0 20030725 on minor 0 --

Packard Bell - Disk Boot Failure, Insert System Disk, and ...
Initializing CPU#0 CPU 0 irqstacks, hard=c035f000 soft=c035b000 PID hash table entries: 2048 (order: 11, 8192 bytes) Detected 1005.045 MHz processor. .... writer cd/rw xa/form2 cdda tray sr 1:0:1:0: Attached scsi CD-ROM sr1 Linux agpgart interface v0.102 ACPI: Invalid PBLK length [5] agpgart: Detected an Intel i815

IDE HD not always detected
The drive is a relatively new Sony DVD writer (Sony DRU-530A), and it occurred to me that it had simply failed, so to test that theory, In correcting some problems detected with SpyBot, I have deleted suspicious Registry entries, but I have been very, very careful that these have not been associated with

Current problem reports assigned to freebsd-usb@FreeBSD.org
but now it is saying no valid recordable device was detected! I am an obvious beginner, but do I need something special on my computer to record dvd's? If you have imported your DV-AVI movie into MyDVD, when you go to burn, you should choose your DVD writer. Did you actually import the DV-AVI?

BSOD (Page_Fault_in_Non_Paged_Area; win32k.sys)
[Warning: troll detected, rest of post removed] Translation-He's for piracy but can't think of a rebuttal that won't make him look like he supports Since the invention of recording tape, xerox machines, cassettes and the DVD writer people have been doing this. I highly doubt there is anyone on earth that hasn't

HELP! Can't record to dvd!
But everything worked fine when I disconnected my DVD-Writer, plus one of my SATA drives. With any one of these, the problem would reappear. Quite often, the disk is no longer detected at startup. Rebooting corrects the problem, which I encounter mostly when the computer comes out of WinXP hibernation.

Sony all-in-one DRU500a DVD writer
I have a Philips CD-writer and a DVD-writer in my windows XP machine. I tried every tip & trick described in the MS knowledge base, had the hardware checked, .. the 2 drives stayed cd-roms for xp. So with the media player & file explorer no data can be written to one of my writer drives (reading is ok).

DVD/CD Problem
Hello there, I'm trying author some SVCD/DVDs with Pinnacle Expression 2.2 But When I start the application, it comes up with a message that 'No CD-R writer or DVD-R disc writer has been detected'. Does any one know of this problem? I called Pinnacle Tech Support and blindly advised that if I have CD burning

Replacing motherboard
When output the finished movie to a CD, the program says no recordable CD drive is detected. In fact, I have both CD writer and DVD writer on my system. Can someone tell me how to configure CD writer attached and if Movie Maker supports DVD output. Thanks, Ray.

DVD Writer set up pls help?????????????
In this case, use of RAID may be causing a kernel overwrite which is later detected as an invalid kptbl entry which triggers the kernel PANIC. My boss decided to take a DVD writer off the box, and this happened when he powered up the system after that. The Octane comes up fine if the RAID is not attached.

Bug#253683: marked as done (kernel parameter example should use ...
Email me via nojay (at) nojay (dot) fsnet (dot) co (dot) uk This address no longer accepts HTML posts. Robert Sneddon I have updated my Via MB drivers and my BIOS to the latest version. I now have my DVD writer and DVD on IDE1 and the CDwriter on IDE2, all are working OK. I have my partitioned Seagate 80 Gb HD on

Bizarre behavior from DVD/CD RW drive - can't burn DVDs
I have an inspiron 510m dell laptop (1.6 GHz Centrino), i bought LG IDE DVD super multi (Model : GSA-4167B) , i connected it to usb port of the laptop through IDE to DVDRAM GSA-4167B>Version: DL13 - HA 1 TA 0 - 6.6.0.15 Adapter driver: <> HA 1 Drive buffer : 2048kB Bus Type : default (0) -> ATAPI, detected: ?

DVD Playback Problems
(NB: If you are a system administrator and have no idea what I am talking about this indicates a serious mail system misconfiguration somewhere. .... Joey Hess - Register the airport module if it's detected so it will be available in the installed system. - apt-install usbutils when installing hotplug to avoid the

Nothing But Coasters
atalla mostafa_ata...@yahoo.com alt comp hardware pc-homebuilt I have an inspiron 510m dell laptop (1.6 GHz Centrino), i bought LG IDE DVD super multi (Model <HL-DT-ST DVDRAM GSA-4167B>Version: DL13 - HA 1 TA 0 - 6.6.0.15 Adapter driver: <> HA 1 Drive buffer : 2048kB Bus Type : default (0) -> ATAPI, detected: ?

Sony DRX-820UL no drivers
No, it's not moot. It *is* the manufacturers responsibility. Those that publish their hardware specs, or share it with Linux developers, or write their own I've only installed four or five CD writers and one DVD writer, but they have all been automatically detected and work. did you install them after your